Neutron as External Signal Processor (Guitars, Vocals, Other Synths) by SpontaneousLightBulb

External Signal Processing Guitar Vocals Filter Only MIDI

1. Plug your external signal source into the Input Jack of the Neutron with a TRS cable.*

2. Open and close the Filter with a sustained MIDI note from your controller.**

*

Use a TRS Y Cable with your Audio Interface by plugging your external signal source into an input that has a corresponding Insert. You use the Y cable by using the Tip for INPUT and Ring for OUTPUT.

Examples below:
SynthDCO OUT => Ch1 IN => Ins1 OUT => Tip => SynthVCF IN => SynthVCF OUT => Ring => Ins1 IN => DAW

Guitar OUT => Ch1 IN => Ins1 OUT (TRS Y cable) => Tip => SynthVCF IN => SynthVCF OUT => Ring => Ins1 IN

**

You must open and close the filter with a MIDI note. You can use syncopated beats to open and close the beats, but it will lose the signal that was transmitted to the filter if a fresh signal is not transmitted once the filter is open (I think?). As a proof of concept, it's easier to just use a sustained MIDI note.

Note:
Feedback can be sent to /user/spontaneouslightbulb on Reddit.